Exterior Finishing: Vinyl / PVC

Designed for use in EIFS and DEFS wall and ceiling systems

These corner beads are hard to damage, rust-proof, and straight.

One-piece Soffit Vent designed for plywood, soffit board, and three-coat stucco

May be combined with Starter Strips / Casing Beads or DEFS Casing Beads.

Designed for exterior soffits where a drip screed and edge reveal need to be combined

Pre-installed soffit edge reveals with a drip edge to direct moisture away from the installation.

Designed for exterior soffits where a drip screed and an edge reveal need to be combined

Used to direct moisutre away from the installation in EIFS and DEFS installations. Always use a rigid backing or blocking material behind surface…

J-bead flanges cover the raw edges of soffit board

One-piece soffit vents provide an economical means for venting soffit areas. Vent clips are provided for proper connection and alignment of the soffit vents. 

Provides an economical means for venting soffit areas

One-piece soffit vent with perforated flanges to assist in embedment of the base coat mixture and to cover the raw edges of the soffit board. Vent clips are provided for proper…

One-piece soffit board designed for venting soffit areas over exterior board in EIFS and DEFS applications

Available with 2", 3", 4" wide vents, each with a 1/8” ground. Vent clips are provided to connect the soffit vent and to assist in…

Vented Channel Reveals facilitate perimeter air flow to assist in moisture management and temperature control

This vent is intended for surface-mount applications. Always use a rigid backing or blocking material behind surface-mounted…

Designed for ceilings when a vented reveal is required at the juncture of a wall and ceiling where horizontal movement may occur

Vent clips are provided to connect reveal sections and to assist in their alignment.